10
If you do not fit batteries you will need to turn this alarm to OFF. To do so, hold both the arrow
icons/buttons to enter the menu. Scroll through until you get to the screen that shows bAt
and touch the tick icon/button. Touch the arrow icon/button to change the screen from on
to OFF and hold the tick icon/button until the display reverts to bAt to conrm the change.
There is a secondary temperature probe at the back of your refrigerator. It is a ‘wandering probe’
you can uncoil and move anywhere in the fridge, for example, placing it in a simulated load to
measure the thermal mass of the product. We recommend it is enabled as data collected by
this probe may be required for compliance and quality reasons etc.
Like probe t1 the controller will alarm if it detects that the temperature is lower than 2oC or
higher than 8C where it is placed. The temperature detected by this probe will display after
the t1 screen. You can tell which one is which because a small t1 or t2 will appear above the
temperature displayed. Likewise you will be able to tell which probe is alarming as the high or
low alarm will be prexed by t1 or t2.
Turning the Battery Alarm O
Temperature Probe t2
To enable the probe, enter the menu by holding the two arrow icons/buttons simultaneously
and scroll until you get to a screen that shows t2.
Touch the tick icon/button to enter the t2 menu and the screen will display OFF. Touch the
arrow icon/button to reveal the on screen and hold the tick icon/button to conrm.
Temperature detected
by probe t1
Temperature detected
by probe t2
To Next Page
Loading...
Need help?
General
