Edition 3 April 2012 Mars/Mars Pro Service Manual
Page 14/59
3.2 Support frames
The Mars cabinet can be supplied with a choice of different support frames to give working heights as follows
9,001,020,011 Adjustable support stand to give work height of 75-80 cm for Mars 900
9,001,020,012 Adjustable support stand to give work height of 75-80 cm for Mars1200
9,001,020,013 Adjustable support stand to give work height of 75-80 cm for Mars1500
9,001,020,014 Adjustable support stand to give work height of 75-80 cm for Mars1800
9,001,030,011 Adjustable support stand to give work height of 90-95cm for Mars 900
9,001,030,012 Adjustable support stand to give work height of 90-95 cm for Mars1200
9,001,030,013 Adjustable support stand to give work height of 90-95 cm for Mars1500
9,001,030,014 Adjustable support stand to give work height of 90-95 cm for Mars1800
9,001,040,011 Adjustable support stand to give work height of 80-85 cm for Mars 900
9,001,040,012 Adjustable support stand to give work height of 80-85 cm for Mars1200
9,001,040,013 Adjustable support stand to give work height of 80-85 cm for Mars1500
9,001,040,014 Adjustable support stand to give work height of 80-85 cm for Mars1800
There is also an electrically adjustable support frame available as follows:
9,001,020,101 Electrical elevation stand 75-105 cm M900
9,001,020,102 Electrical elevation stand 75-105 cm M1200
9,001,020,103 Electrical elevation stand 75-105 cm M1500
9,001,020,104 Electrical elevation stand 75-105 cm M1800
When delivered the support frames are flat packed and need to be assembled. Each frame will consist of 3 components :-
the rear bracket / kick panel (C), and 2 side frames, (D).
To assemble the frame screw the rear panel (C) to the side frames in
positions (A) using the screws supplied with the frame ensuring that the
rear panel is mounted so as to be flush with the top of the frame and the
lipped side faces rearwards. The frame height can be adjusted up to
50mm by screwing in or out the feet (B). Ensure they are locked into
position with the locking nuts and that the frame is level before
lowering the cabinet onto the support frame.
Once the cabinet is in position then secure the cabinet to the frame by
screwing in the retaining screws into positions (E) which will ensure the
cabinet is correctly fixed to the frame. Access to these screws is from
under the top frame crossbar.
To Next Page
Loading...
Need help?
General
