Edition 3 April 2012 Mars/Mars Pro Service Manual
Page 17/59
Item No 10 Spare light tube
Two light tubes are installed in each Mars cabinet above the laminator sheet. To access the light tubes, the laminator sheet
must first be removed. (See fig 3 below)
To access the laminator sheet it is first necessary to raise the motorized window to the highest position allowing a fully
open work area.
1. Pull the 2 ribbons on the laminator towards the front of the
cabinet
to compress the sprung brackets (see (A) below in Fig 5) and
then
downwards to the base of the cabinet. This will allow the
laminator
and frame to drop down. Take care to avoid it dropping
completely
and causing damage.
2. Remove the laminator from the cabinet and place in a secure place
to avoid inadvertent damage. Fig. 3.
3. The fluorescent light tubes can then be seen along the top front and
rear of the cabinet work area. (See Fig 4)
4. Ensure the power is turned off and rotate the tube through 90º so
5. the tube is free of the connections and carefully remove it from the Fig 3 Removal of cabinet. Laminator
6. Repeat the procedure with the other tube if both are to be replaced.
7. Insert a new tube in the reverse procedure.
8. Replace the laminator by positioning it carefully towards the front of the cabinet and then raising into position at
the back, locating it securely above the flanges around the edge of the work zone.
Fig. 4. Showing light tube at rear. Fig. 5. Showing clips (A).
Cat. No.:
9.000.050.007 Light ballast for Mars/Fortuna 900 – 1200
9.000.050.008 Light ballast for Mars/Fortuna 1500 – 1800
9.000.040.011 Light tube for Mars/Fortuna 900
9.000.040.012 Light tube for Mars/Fortuna 1200
9.000.040.013 Light tube for Mars/Fortuna 1500
9.000.040.014 Light tube for Mars/Fortuna 1800
To Next Page
Loading...
Need help?
General
