Lamtec KS1D User Manual

34
5 Maintenance
5.1.12 Settings
Adjusting the settings depends on the current access level. Access level 2 (service level) al-
lows to adjust all settings.
5.1.12.1 Maintenance Mode
In SETTINGS, select (see Chapter 5.1.5 Activate/deactivate Maintenance Mode.)
5.1.12.2 Filter Time
5.1.12.3 Analogue Outputs
In SETTINGS, select for analogue outputs (see Chapter 8.1.3 Conversion of the Output
Range via the User Interface).
Select in the MAIN MENU for the set-
tings.
SETTINGS allows the following:
Maintenance mode (level 0) see chapter
5.1.12.1 Maintenance Mode
Filter time for the measured values
(level 0)
Analogue outputs (level 1) see chapter
8.1.3 Conversion of the Output Range
via the User Interface
Probe replacement (level 1)
Display (level 0)
Limit values (level 1)
Digital outputs (level 2)
Filter time of the measurement values:
No access level required.
The filter time is the duration within which the
measured values are averaged.
Factory setting:
O
2
measured value 2 s

Lamtec KS1D Specifications

General

Brand	Lamtec
Model	KS1D
Category	Transmitter
Language	English