Contents
WiBox2100E User Guide 6
Obtaining Firmware _____________________________________________________77
Reloading Firmware ____________________________________________________77
Using TFTP: Graphical User Interface ______________________________________77
Using TFTP: Command Line Interface ______________________________________78
Network Upgrade_______________________________________________________78
Recovering the Firmware Using the Serial Port and DeviceInstaller ________________78
WLAN Country Setting __________________________________________________79
11: Wireless Bridging 80
Configuring the WiBox in Bridging Mode_____________________________________80
Method 1 __________________________________________________________________80
Method 2 __________________________________________________________________80
Method 3 __________________________________________________________________81
12: Troubleshooting 82
Diagnostic LED States___________________________________________________82
Problems and Error Messages ____________________________________________82
Technical Support ______________________________________________________85
A: Binary to Hexadecimal Conversions 86
Converting Binary to Hexadecimal _________________________________________86
Conversion Table ___________________________________________________________86
Scientific Calculator _________________________________________________________86
Compliance 88
Compliance Information__________________________________________________88
Regulatory Information __________________________________________________89
USA Federal Communications Commission (FCC) Notice____________________________89
Canada – Industry Canada Notice ______________________________________________89
Europe – R&TTE Directive 99/5/EC, Wireless Notice _______________________________90
Australia & New Zealand – Wireless Notice _______________________________________90
Warranty 92
List of Tables
Table 2-1. WiBox LEDs ______________________________________________________ 17
Table 2-2. WiBox Technical Specifications _______________________________________ 18
Table 6-1. BootP/DHCP/AutoIP options__________________________________________ 47
Table 6-2. Standard IP Network Netmasks _______________________________________ 48
Table 7-1. Interface Mode Options______________________________________________ 51
Table 7-2. Common Interface Mode Settings______________________________________ 51
Table 7-3. Flow Control Options________________________________________________ 52
Table 7-4. Reserved Port Numbers _____________________________________________ 52
Table 7-5. Connect Mode Options ______________________________________________ 53
7-6. Modem Mode Commands_________________________________________________ 59
Table 7-7. Disconnect Mode Options ____________________________________________ 60
Table 7-8. Flush Mode Options ________________________________________________ 61
Table 7-9. Pack Control Options _______________________________________________ 62
Table 9-1. Monitor Mode Commands ____________________________________________ 75
Table 9-2. Command Response Codes __________________________________________ 76
Table 10-1. Firmware Files____________________________________________________ 77
To Next Page
Loading...
Need help?
General