Launch X-431 V+ User Manual

LAUNCH X-431 V+ V4.0 User Manual
15
3 Network Setup
Note: If you don’t need to use Wi-Fi for a while, you can turn it off to conserve
battery life.
The tablet has built-in Wi-Fi that can be used to get online. Once you’re online,
you can register your tool, surf the Internet, get apps, send email, launch the
remote diagnosis, and check for software updates etc.
3.1 Connect to a Wi-Fi Network
1. On the home screen, tap
Settings -> Network & Internet -> WLAN
.
2. Slide the Wi-Fi switch to ON, the tablet starts searching for available wireless
networks.
3. Select a wireless network,
 If the chosen network is open, the tablet will connect automatically.
 If the selected network is encrypted, a network password will need to be
entered.
4. When “Connected” appears, it indicates the Wi-Fi connection is complete.
Note: When Wi-Fi is not required, this should be disabled to conserve battery
power.
Once it is connected successfully, tap the desired Wi-Fi network from the list to
view its name, link speed, security type, IP address etc.
When this tool is in range, it will connect to the previously linked network
automatically.
3.2 Disconnect from a Wi-Fi Network
1. On the home screen, tap
Settings -> Network & Internet -> WLAN
.
2. Tap the network with a
Connected
status, then tap “Disconnect”.

Launch X-431 V+ Specifications

General

Brand	Launch
Model	X-431 V+
Category	Diagnostic Equipment
Language	English