Leica iCON gps 70 User Manual

5. Clamp the compression lock. The compression lock maintains
s
traightness.
6. Fix the holder to the clamp with the tightening screw. Before tight-
ening, ensure that the holder is at a comfortable working height and
angle. This can be achieved by sliding the clamp along the pole and
rotating the holder about the clamp. Tighten the tightening screw.
7. Insert the battery into the field controller.
8. Clip the field controller onto the holder and lock into position.
9. Turn on the antenna and the controller.
10. Run the data collection or stake-out application of the iCONstruct
Field software
☞
Refer to the iCONstruct Field software manual for further informa-
tion.
4.1.4 Holder and Clamp for Field Controller
010936_002
d
f
a
g
h
e
b
c
Clamp
a Tightening screw
b
Pole clamp
c Clamping bolt
Holder
d Mounting arm
e Locking lever
f Mounting brackets (side)
g Mounting brackets (bottom)
h Holder for stylus
Holder for iCON CC80
Operation 33

Leica iCON gps 70 Specifications

General

Brand	Leica
Model	iCON gps 70
Category	Receiver
Language	English