6 of 21 7 of 21
2.3 Display
The screen shows various menus, dialogues and displays as described below.
There are basically six types of screen:
Ÿ Standby (clock)
Ÿ Splash (mode)
Ÿ Now playing
Ÿ Dialogue
Ÿ Error/Information
Ÿ Menu
When text is too long to fit on the screen, it is first shown truncated, then after
a few seconds, slowly scrolls so that you can read it all. The Standby screen
shows the time, date and any active alarm times.
As you cycle through the play modes using SOURCE, CR2 shows a
splash screen for each mode. After one second, CR2 enters the selected
mode and tries to start playing the last station or track that was playing in that
mode. If this is not possible, CR2 tries to connect to the selected source
by scanning for stations, or prompting for user input as appropriate.
Now playing screens show information about the audio source and track now
playing, where available.
Dialogue screens are shown to allow the user to change settings.
Error/Information screens give specific messages for a few seconds, then
change automatically to another screen
.
Menus
CR2 has basically three types of menu. Use the Select control to step
through and select options. A scroll bar on the right of the screen shows if
there are further options above or below those visible.
Each mode has a Mode menu, with options specific to that mode.
Below for DAB mode menu as an example.
System settings >.The '>' indicates options leading to further menus.
The System settings menu allows access to system settings and information such
as time, language and software update.
Menus with more options than will fit on one screen have a ">"in the right.
Some menus, for example the System settings menu, have several submenus.
3. Started and setup
CR2 is easy to use. To play DAB or FM radio, all you need is a power
source (a 100-240 V mains supply);
1. Place CR2 on a suitable shelf or table.
2. Extend the telescopic antenna.
3. Connect the power adaptor between CR2 and the mains supply.
3.1 12/24 hour display
To change between 12 and 24 hour display, select Set 12/24 hour and then
select your preference.
3.2 Time/date
The time and date can be updated manually or automatically.
To Next Page
Loading...
Need help?
General
