Page 2
506044−01 06/08
Unit Dimensions − Inches (mm) and Parts Arrangement
4−5/8
(117)
39.40"
(1003)
35.50"
(902)
18.60"
(470)
8.00"
(203)
1 (25)
LIQUID LINE
INLET
SUCTION LINE
INLET
ELECTRICAL
INLETS
BASE WITH ELONGATED LEGS
SIDE VIEW
ACCESS VIEW
DISCHARGE AIR
LOW PRESSURE
SWITCH
OUTDOOR FAN
COMPRESSOR
AND SOUND
REDUCTION
COVER
[−024] 41 (1040)
[−030 THROUGH −060]
47 (1194)
16−7/8
(429)
8−3/4
(222)
26−7/8
(683)
3−3/4 (95)
30−3/4
(781)
3−1/8
(79)
UNIT SUPPORT FEET
XC15 PARTS ARRANGEMENT
HIGH PRESSURE
SWITCH
COMPRESSOR
TERMINAL PLUG
FILTER DRIER
SYSTEM OPERATION
MONITOR
CONTACTOR
RUN CAPACITOR
DISCHARGE LINE
MUFFLER
SUCTION VALVE AND
GAUGE PORT
SUCTION LINE
WARNING
This product and/or the indoor unit it is matched
with may contain fiberglass wool.
Disturbing the insulation during installation,
maintenance, or repair will expose you to fiberglass
wool dust. Breathing this may cause lung cancer.
(Fiberglass wool is known to the State of California
to cause cancer.)
Fiberglass wool may also cause respiratory, skin,
and eye irritation.
To reduce exposure to this substance or for further
information, consult material safety data sheets
available from address shown below, or contact
your supervisor.
Lennox Industries Inc.
P.O. Box 799900
Dallas, TX 75379−9900
VIBRATION ISOLATOR SLEEVE
LOCATIONS ON −024, −030 AND
−036.
DO NOT REMOVED THE THREE VIBRATION ISOLATOR SLEEVES (IF
PRESENT) FROM THE COMPRESSOR DISCHARGE LINE
NOTE: ON THE −042, ALL THREE
VIBRATION ISOLATOR
SLEEVES ARE LOCATED ON
THE HORIZONTAL SECTION OF
THE DISCHARGE LINE.
Figure 1. Discharge Line Vibration Isolators
To Next Page
Loading...
Need help?
General
