Lenze
1-6
8200 motec/starttec en 12/03
1
Product information
Distributed drive solutions with 8200 motec/starttec – Robust by design
Current drive technology requirements in machine and
system production can be attributed to the following key
issues:
• Simple drive concepts minimise project planning
• Reduction in assembly times due to ease of handling,
installation and assembly
• High system availability due to a reduction in
maintenance requirements and an increase in the speed
at which components can be replaced
• Reusability due to complete systems based on modular
designs
• Adaptability due to the flexible use of drive components
Distributed drive solutions are ideal for these requirements.
Lenze can provide you with the
necessary components for consistent implementation.
The features and functions required to implement
distributed drive solutions efficiently will be described in
more detail later in this document.
Power range
8200 motec frequency inverters for single and
three-phase mains connection
Power ratings 230 V, 0.25 - 0.37 kW
400/500 V, 0.55 - 7.5 kW
starttec motor starter for three-phase mains connection
Power rating 100-500 V, 0.25 - 4.0 kW
How this helps you:
– Consistent and universal implementation of distributed
drive solutions throughout a wide power range
– Suitability for use all over the world due to an input
voltage range of up to 500 V (+10% )
and certification to international standards
Universal
The 8200 motec provides the same range of functions as
the 8200 vector frequency inverter (IP20 protection).
Many features, such as parameter settings, operation,
diagnostics and fieldbus interface are the same, even on
the starttec motor starter.
How this helps you:
– Any combination of central and distributed drive
components are available for each system concept
– Reduction in the time and money spent on project
planning and training
Adaptable
The modular structure enables the 8200 motec and starttec
to be optimised for your application..
Whether you simply wish to start up motors or change
speeds, run a "standalone" inverter with setpoint selection
via potentiometer or as a networked inverter with speed
feedback in master/slave mode, the range of functions can
be adapted to the application on the basis of the features
required.
How this helps you:
– Cost-effective drive solutions due to ideally
matched components
Flexible
Both the 8200 motec and the starttec support most
common fieldbus systems.
How this helps you:
- The ideal BUS system (CAN, PROFIBUS-DP, INTERBUS,
AS-Interface) for every requirement and every application
To Next Page
Loading...
Need help?
General