Lenze 9300 Series User Manual

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
3
 21
EDKVF93−03 EN 2.0
3.1.4 Changing and saving parameters
 Note!
Your settings have an effect on the current parameters in the main memory.
You must save your settings in a parameter set so that they are not lost when
the mains are connected.
If you only need one parameter set, save your settings as parameter set 1,
since parameter set 1 is loaded automatically after mains connection.
Step Key
sequence
Action
1. Select the menu   ! " Use the arrow keys to select the desired menu
2. Change to the code level ! Display of the first code in the menu
3. Select code or subcode  
Display of the current parameter value
4. Change to the parameter level 
5. When SHPRG is displayed, inhibit the
controller
$
1)
The drive coasts
6.
Change parameter
A ! " Move cursor below the digit to be changed
B
  Change of digit
 
 
Quick change of digit
7.
Accept the changed parameter
Display of SHPRG or SHPRG    Confirm change to accept the parameter
Display "OK"
Display  − The parameter has been accepted immediately
8. Enable the controller, if required #
1)
The drive runs again
9.
Change to the code level
A  Display of the operating level
B  Display of the code with changed parameter
10. Change further parameters Restart the "loop" with step 1. or 3.
11.
Save changed parameters
A   ! " Select the code C0003 "PAR SAVE" in the menu
"Load/Store"
B  Change to the parameter level
Display "0" and "READY"
Select the parameter set in which
the parameters are to be saved
permanently
C 
Save as parameter set 1:
ð Set "1" "Save PS1"
Save as parameter set 2:
ð Set "2" "Save PS2"
Save as parameter set 3:
ð Set "3" "Save PS3"
Save as parameter set 4:
ð Set "4" "Save PS4"
D   When "OK" is displayed, the settings are permanently
saved in the selected parameter set.
12.
Change to the code level
A  Display of the operating level
B  Display of C0003 "PAR SAVE"
13. Set parameters for another parameter
set
Restart the "loop" with step 1. or 3.
1)
The function of the $ key can be programmed:
C0469 = 1: Controller inhibit
C0469 = 2: Quick stop (Lenze setting)
efesotomasyon.com - Lenze

Lenze 9300 Series Specifications

General

Brand	Lenze
Model	9300 Series
Category	Controller
Language	English