1 Preface
EDBC250SBC |1.1
l
ll
l
4
1 Preface
1.1 Version information
Date Comments / modification
31/01/2017 Version 1.0
02/08/2017 Version 1.1
1.2 Information about this Operating Instructions
This Operating Instructions contains general Information for parameterization, configuration
and diagnosis of the Lenze Safety System.
Target Group
This Operating Instructions is directed to Persons, who project and setup the Lenze Safety
System with the Engineering Tool
Information
Information and Tools about the Lenze Products can be found in the Internet
http://www.lenze.com ► Download
Copyright
Microsoft®, Windows® and the Windows® logo are registered trademarks of Microsoft Corp. in
the USA and other countries.
EtherCAT® is a registered trademark and patented technology, licenced by Beckhoff
Automation GmbH, Germany.
Further information about the PLCopen organisation is available at www.plcopen.org.
Title to all companies and company names mentioned heron as well as to products and
product names is held by the respective enterprises.
Structure and goal of this Operating Instructions
This guide aims to familiarize you with the use of the modules.
In examples preferably »PLC Designer« Version 3.14 and the Lenze Controller 32xx C which
contains an EtherCAT Master is used.
Further knowledge of the programming in accordance with IEC 611131-3, please refer to the
»PLC Designer« online help or the literature.
For beginners in »PLC Designer« it may be appropriate to use the comprehensive training offer
from Lenze.
1.2.1 Literature
EtherCAT, Technology, FAQs, Downloads
SPS Programmierung nach IEC 61131
To Next Page
Loading...
Need help?
General
