Mechanical installation
Important notes
4
19
Lenze ¯ MA 12.0012 ¯ 4.0
4 Mechanical installation
4.1 Important notes
¯ The transport weights can be found in the shipping documents.
¯ Use lifting devices for the transport!
¯ Before transport
– check that all component parts are safely mounted,
– fasten all transport aids (eye bolts or support plates).
Danger!
Danger due to toppling or falling loads!
¯ The payload of the hoists and load handling devices must at least
correspond to the weight of the load.
¯ Secure the load handling device so that it won’t slip from its position.
¯ The load must be secured in such a way that it cannot topple or fall
down.
¯ Do not stay under a pending load!
4.2 Transport
Stop!
Observe load carrying capacity!
Standing beneath floating loads is prohibited!
Danger!
The motors attached to the gearbox are partially equipped with eyebolts.
They are exclusively determined for mounting/dismounting the motor to
the gearbox and must not be used for the complete geared motor!
The following figures show the position of the transport threads. As a standard,
gearboxes from size g500−H210/G50BH121 onwards come with a transport thread for
eye bolts in compliance with DIN 580 in the gearbox cover. In the case of smaller drives,
the thread in the output shaft can be used. The eye bolt is not included in the scope of
supply!
To Next Page
Loading...
Need help?
General
