4
Levo Retailer Technical Guide
Requirements & Recommendations
Required Tools
Turbo PC Connect and Diagnostic Tool,
version 4.2 or later : 989E-5610
This is an updated version of the existing Turbo PC Connector
(aka Turbo Diagnostic Tool). This tool is used exclusively to
update the Levo system firmware of the motor and battery.
All system diagnosis can be performed electronically with the
Mission Control App or manually with the diagnosis techniques
outlined in the Troubleshooting Guide section of this guide.
To update the motor firmware, the Levo Diagnosis Tool Adapter must
be used in conjunction with Turbo PC Connect and Diagnostic Tool.
Note: previous versions of the Turbo PC Connect and
Diagnostic Tool will only update the battery firmware. The
previous versions will not update the motor firmware.
Levo Diagnosis Tool Adapter : 98916-5646
The adapter must be used with the Turbo PC Connect
and Diagnosis Tool to update the motor firmware. In
addition, the battery must be connected to the motor
while the Turbo PC Connect performs the update.
3" 2-jaw pulley and gear puller
These tools are typically available at auto parts and/or hardware stores.
The ends of the jaws must be thin enough to fit between the chainring
spider and motor cover. The force required to pull the spider is low.
Therefore, if the ends of the jaws need to be modified or ground
down to fit between the spider and motor, that is acceptable.
To Next Page
Loading...
Need help?
General
