ENGLISH
14
ASSEMBLING AND PREPARING
Using the kensington security
system
The Kensington security system connector is
located at the back of the TV. For more information
of installation and using, refer to the manual
supplied with the Kensington security system or
visit
http://www.kensington.com
.
Connect the Kensington security system cable
between the TV and a table.
The Kensington security system is optional.
You can obtain additional accessories from
most electronics stores.
NOTE
Tidying cables
Gather and bind the cables with the supplied
cable tie.
Do not move the TV by holding the cable tie, as
the cable tie may break, and injuries and damage
to the TV may occur.
CAUTION
When you adjust the angle, do not hold the
bottom of the TV frame as shown on the
following illustration. It may injure your fingers.
WARNING
Disconnect the power cord first, and then move
or install the TV. Otherwise, electric shock may
occur.
CAUTION
Tilt from +20 to -5 degrees up or down to
adjust the angle of the TV to suit your view.
NOTE
Front Rear
+20-5
To Next Page
Loading...
Need help?
General
