- 14 -
LGE Internal Use OnlyCopyright ©2010 LG Electronics Inc. All rights reserved.
Only for training and service purposes
* Auto-control interface and directions
(1) Adjust in the place where the influx of light like floodlight
around is blocked. (Illumination is less than 10ux).
(2) Measure and adjust after sticking the Color Analyzer (CA-
100+, CA210 ) to the side of the module.
(3) Aging time
- After aging start, keep the Power on (no suspension of
power supply) and heat-run over 5 minutes
*Above optical characteristics are should be measured by
following condition.
O DDC Adjustment Command Set
Measured Mode
Picture Mode Vivid
Fresh Contrast Off
Fresh Color Off
Smart Power Saving Off
Adjustment
Adjustment
Adjustment