20
PROGRAMMING MODE
- OPL type -
How to enter "Programming mode"
You can enter programming mode only for Idle state and
pause state.
- OPL Type
1) Push the 90°C MEDICAL & 60°C NORMAL button at the
same time.
2) Push the 75°C HOT button 1 times.
3) Push the START button.
4) Display will show “ ”.
How to use button
You can change Washer vend price, cycle time and Cycle
parameters, etc.
: You can check machine information or change setting on “Program setup”, “Collect Information Data”, ”Diagnostic Test”.
PROGRAMMING MODE
Press Button Description
90°C MEDICAL
Move to upper level or
Comes back to Idle State
75°C HOT Move to the mode in the same level (+)
60°C NORMAL Move to the modes in the same level (-)
START Enter the selected mode
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display “ ”.
• The machine will display “PUSH” for OPL type
To Next Page
Loading...
Need help?
General
