29
PROGRAMMING MODE - SETUP MODE
NOTE
• This function is only controlled in machine.
(It is not applied in setup card.)
Entering set up mode.
You will see LqC1
Button Display
Press the
90°C MEDICAL
button.
Press the
75°C HOT
or the
60°C NORMAL
button until appears in the
display.
Press the
START
button.
Press the
75°C HOT
or the
60°C NORMAL
button until appears in the
display.
Press the
START
button.
Press
75°C HOT(+)
or
60°C NORMAL(-)
button and then select
, ,
23.7 [KHz]
MIDDLE : 22.8 KHz -> 23.7 KHz (default)
22.8 KHz -> 23.5 KHz
One or the other will
display.
Press the
START
button.
The machine sets up the value of water level, then advances to the next process
automatically.
If this function is restricted originally in program,
You can move to the next step by pushing the 60°C NORMAL button.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• OPL type - Push the 90°C MEDICAL button twice.
6. How to change the water level
You can change the water level by selecting two options.
1. LO indicate water level 23.7 [KHz]
2. HI indicate water level 23.5 [KHz]
To Next Page
Loading...
Need help?
General
