PROGRAMMING MODE –SETUP MODE
Setup Mode : (display)
You can change washer vend price, cycle time, and cycle parameters, etc.
Entering setup mode
- Coin type – Turn on/off toggle switch.
- Card type – Insert the service card.
- All types – 1) Push the Hot & Cold button at the same time.
2) Push the Warm button 3 times.
3) Push the Start button.
- Then, the washer displays .
1. How to change regular price.
Enter setup mode.
You will see LqC1
Button Display
Press the
Hot
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the
Start
button.
Press the
Start
button.
Display previous regular price.
Press
Warm(+)
or
Cold(-)
button to set the regular price.
(The vend price can be set from 0~10.00 in 0.1
increments.)
Press the
Start
button.
The machine sets up the regular price, then advances
to the next process automatically.
1. Continue to set up the next price.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the Hot button twice.
NOTE
• Price setting varies by country
• Set your country from mode (Refer
How to enter the
)
• After EEPT, reset your country (Default country is EUK)
To Next Page
Loading...
Need help?
General
