NOTE
• This function can be set only at the machine. It cannot be managed via the setup card.
(It is not applied in setup card.)
23. How to change the water level
You can change the water level by selecting two options.
1. indicate water level 23.5 [KHz]
2. indicate water level 23.0 [KHz]
3. indicate water level 22.8 [KHz]
Enter setup mode.
You will see LqC1
Button Display
Press the
Hot
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the
Start
button.
Press the
Warm
or the
Cold
button until appears
in the display.
Press the Start button. Display .
Press Warm or Cold button to select course.
: Hot course
: Warm course
: Cold course
: Delicates course
: None (only for Heater model)
Press the
Start
button.
Press
Warm(+)
or
Cold(-)
button and then select
or or
23.5 [KHz] 23.0 [KHz] 22.8 [KHz]
One or the other
will display.
Press the
Start
button.
The machine sets up the value of water level, then
advances to the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type – Turn on/off toggle switch.
• Card type – Insert the service card.
• All types – Push the Hot button three times.
To Next Page
Loading...
Need help?
General
