To Next Page

To Previous Page

206-4290

FMA-LG102 Conguration

Overview

Once you have completed the required steps to set the PC’s network connections, you can update

the FMA-LG102 using either the FTG Device Configuration Application software (v5.5.0 or later) or the

FMA-LG102 software web page.

Experienced installers can refer to the FMA-LG102 configuration quick reference overviews below if

extended directions are not required. Otherwise, proceed to the appropriate section depending on whether

you are using the FTG Device Configuration Application software or the FMA-LG102 software web page:

• “FMA-LG102 Conguration using the FTG Device Conguration Application Software” on pages 14 to 15

• “FMA-LG102 Conguration using the FMA-LG102 Software Web Page” on pages 15 to 16

FMA-LG102 Configuration Prerequisites

• The FMA-LG102 must be installed and set up in the equipment rack prior to conguration (see FMA-

LG102 installation and cabling information on previous pages).

• You will need to know the IP address of the FMA-LG102 (see “FMA-LG102 Ethernet Connection/Network

Options” on previous page).

Network Ethernet connection: Consult the network administrator to obtain the IP address that has been

assigned by a DHCP server to the FMA-LG102.

Direct Ethernet connection: The FMA-LG102 uses its default IP address (10.20.1.120).

• Create a new or identify an existing FMA Conguration (.fma) le to use for updating the FMA-LG102

(see “Creating an FMA Conguration File” on pages 8 and 9, as necessary).

FMA-LG102 Configuration Quick Reference (FTG Device Configuration Application Software)

1. Launch the FTG Device Conguration Application (v5.5.0 or higher), and access the FMA Conguration

Utility. *

2. Set the FMA Utility’s IP address.

3. “Write” the appropriate FMA Conguration le to the FMA-LG102.

4. Set the FMA clock. (Note that the date and time must be set on the PC running the FTG Device

Configuration Application prior to an attempt to set the FMA clock.)

5. Set the FMA broadcast rate.

6. Connect the FMA-LG102 to the RF distribution system as described on page 11.

FMA-LG102 Configuration Quick Reference (FMA-LG102 Software Web Page)

1. Launch a web browser, type the appropriate IP address in the browser’s address bar, and press Enter.

2. Set the date and time parameters and the broadcast rate, and then update the FMA-LG102.

3. Update the FMA-LG102 with an FMA Configuration file.

4. Connect the FMA-LG102 to the RF distribution system as described on page 11.

* If the configuring PC is running Windows Home Premium software, you must run the FTG Device Configuration

Application as an administrative user in order to communicate with and configure the FMA-LG102.

LG FMA-LG102 User Manual

Questions and Answers: