206-4290
6
Installation and configuration of the Free-To-Guest (FTG) Management Appliance (FMA-LG102) requires
the following hardware, equipment, and software.
At the Head End
__ Contents of FMA-LG102 carton:
• FMA-LG102 unit
• Power supply (9V DC 1.25A)
• 75 ohm coaxial terminator (FMA-LG102 RF IN port termination)
• 7-foot Ethernet crossover cable (direct connect PC to congure FMA-LG102)
__ Configuration of the FMA-LG102 requires a PC with an Ethernet port and the FTG Device
Configuration Application v5.5.0 or later installed. FTG Device Configuration Application software
is available online at: www.lg.com/us/commercial/display-solutions/ftg.
At the Room
__ An LG TV must be equipped with one of the following FTG devices:
• EBL (Embedded b-LAN™)
• LMT7Z9 MPI card
• LMT7Z7 MPI card (requires rmware update—see note below)
Note: Please contact the LG Sales team to obtain a Firmware Update (.mot) file, as necessary, for
use with an LMT7Z7 MPI card. You can then use the Firmware Downloader Utility available from the
FMA-LG102 software web page to upload the latest firmware to the FTG device(s). See Reference
section, “FTG Device Firmware RF Downloader,” for detailed instructions.
Note: An HCS1410 FTG card is not compatible with the FMA-LG102.
Setup Checklist
To Next Page
Loading...
Need help?
General
