206-4290
16
FMA-LG102 Conguration (Cont.)
(Continued from previous page)
2. Once you have accessed the FMA-LG102 web page, configure the FMA clock and broadcast rate and
update the FMA-LG102 configuration as described below.
Set the Date and Time Configuration for the FMA-LG102
a. Complete the following fields, as required:
• Month: Click the down arrow at the right of the eld, and select the appropriate month from the
drop-down list of options.
• Day of Month (1–31); Year (2009–2047); Hour (0–23); and Minutes (0–59): Type the appropriate
values in these elds. Note that the Hour eld is based on a 24-hour clock.
• DST Enable?: Click the down arrow at the right of the eld, and select the appropriate option.
“Yes” (default) enables or “No” disables automatic US Daylight Saving Time observance.
b. The Rate (0 or 60–999) field determines the interval, in seconds, at which to repeat the broadcast of
the date & time, the FTG Channel Map, and the FTG Installer Menu profile(s). (FMA-LG102 factory
default broadcast rate is 300 seconds.) Type the number of seconds (60–999) for the broadcast rate
(“0” disables data broadcasting). Note that an error message will be displayed if the broadcast rate is
set to any value from 1 to 59.
c. Click the Update Date & Time button.
Note: After you click the Update Date & Time button, the screen will begin to refresh/
reload. Wait for the screen to com
pletely reload before proceeding. To refresh the
date
and time to the current settings, click the green Refresh button to the right of the Update
Date & Time button. Do NOT use the web browser Refresh button!
Update the FMA-LG102 Channel and TV Configuration (with an FMA Configuration File)
a. Click the Browse button at the right of the Config File to Update field.
b. Browse to the desired FMA Configuration (.fma) file, select the file, and click the Open button.
c. Confirm that the path shown in the Config File To Update field is correct for the FMA Configuration
file selected, and then click the Update Config button to update the configuration on the FMA-
LG102.
Note: After you click the Update Config button, the screen will begin to refresh/reload. This process
may take a few seconds to completely transfer and save the file to memory. Wait for the screen to
completely reload before proceeding.
3. Connect the FMA-LG102 to the RF distribution system as described on page 11.
To Next Page
Loading...
Need help?
General
