To Next Page

To Previous Page

Recommended installation methods

When Installing in a Straight Line in Front of

the TV Screen

1. Before turning on the TV, ensure that the front LED of the Zero Connect

Box is facing the wireless signal receiver of the TV screen.

2. If the front LED is not facing the wireless signal receiver of the TV screen,

turn the dial on the top of the Zero Connect Box left or right to adjust the

direction of the sliding button to face the wireless signal receiver.

3. Adjust the sliding button on the Zero Connect Box towards the top LED.

• Once the dial and sliding button adjustments are completed, the signal

transmission and reception path should be in the green direction shown

in the figure.

4. After turning on the TV, check if the top LED colour of the Zero Connect

Box is blue.

• If the LED is not blue, adjust the dial and sliding button further to

optimise the signal condition.

• Ensure that there are no obstacles in the antenna transmission path.

• Install the Zero Connect Box within 10m of the TV screen. (provided that

there are no obstacles in the way.)

• The signal transmission angle of the Zero Connect Box is 45° left and

right. If your TV screen is outside 45°, please refer to the diagonal or side

mounting method.

When Installing Diagonally in Front of the TV

Screen