To Next Page

To Previous Page

When Installing Beside the TV Screen

1. Before turning on the TV, ensure that the front LED of the Zero Connect

Box is facing the wireless signal receiver of the TV screen.

2. If the front LED is not facing the wireless signal receiver of the TV screen,

turn the dial on the top of the Zero Connect Box left or right to adjust the

direction of the sliding button to face the wireless signal receiver.

• If the front LED of the Zero Connect Box faces the viewing direction, turn

the dial left or right until it is at a 90° angle.

3. Adjust the sliding button on the Zero Connect Box to the centre.

• Once the dial and sliding button adjustments are completed, the signal

transmission and reception path should be in the green direction shown

in the figure.

4. After turning on the TV, check if the top LED colour of the Zero Connect

Box is blue.

• If the LED is not blue, adjust the dial and sliding button further to

optimise the signal condition.

• Ensure that there are no obstacles in the antenna transmission path.

• Install the Zero Connect Box within 3m of the TV screen. (provided that

there are no obstacles in the way.)

• When using a floor stand, adjust the position so that the stand does not

cover the wireless transmitter of the Zero Connect Box.

When Installing Below the TV Screen

1. Before turning on the TV, ensure that the front LED of the Zero Connect

Box is aimed at the viewer facing the TV screen.

2. Turn the dial on the top of the Zero Connect Box left or right to adjust the

direction of the sliding button towards the viewer.

3. Adjust the sliding button on the Zero Connect Box in the opposite

direction of the top LED.