Stereo Audio Record and/or Playback is not present.
b TV is not Stereo-compatible.
b Broadcast program is not in stereo format.
b The A/V Output jacks on the unit are not connected to TV A/V In jacks.
Specifications
General
Power requirements AC 200-240V, 50/60 Hz
Power consumption 23W
Dimensions (approx.) 430 X 78.5 X 260 mm (w x h x d) without foot
Net weight (approx.) 4.2 kg
Operating temperature 5˚C to 35˚C
Operating humidity 5 % to 90 %
Television system PAL B/G, PAL I/I, SECAM D/K, color system
Recording format PAL
System
Laser Semiconductor laser, wavelength 650 nm
Video head system Double azimuth 6 heads, helical scanning
Signal system PAL
Recording
Recording format DVD Video Recording, DVD-VIDEO
Recordable media DVD-RW, DVD-R, DVD+RW, DVD+R,
Recordable time DVD (4.7GB): Approx. 1 hour (XP mode),
2 hours (SP mode), 4 hours (LP mode),
6 hours (EP mode), 14 hours (MLP mode)
Video recording format
Sampling frequency 27MHz
Compression format MPEG2 (VBR supported)
Audio recording format
Sampling frequency 48kHz
Compression format Dolby Digital
Playback
Frequency response DVD (PCM 48 kHz): 8 Hz to 22 kHz,
CD: 8 Hz to 20 kHz
DVD (PCM 96 kHz): 8 Hz to 44 kHz
Signal-to-noise ratio More than 100 dB (AUDIO OUT connector)
Harmonic distortion Less than 0.008% (AUDIO OUT connector)
Inputs
Dynamic range More than 95 dB (AUDIO OUT connector)
ANTENNA IN Antenna input, 75 ohms
VIDEO IN 1.0 Vp-p 75 ohms, sync negative,
RCA jack x 1 / SCART x 2
AUDIO IN 2.0 Vrms more than 47 kohms, RCA jack
(L, R) x 1 / SCART x 2
DV IN 4 pin (IEEE 1394 standard)
Outputs
VIDEO OUT SCART x 2
S-VIDEO OUT (Y) 1.0 V (p-p), 75 Ω, sync negative,
Mini DIN 4-pin x 1(C) 0.3 V (p-p) 75 Ω
COMPONENT VIDEO OUT (Y) 1.0 V (p-p), 75 Ω, sync negative,
RCA jack x 1, (PB)/(PR) 0.7 V (p-p), 75 Ω,
RCA jack x 2
Audio output (digital audio) 0.5 V (p-p), 75 Ω, RCA jack x 1
Audio output (optical audio) 3 V (p-p), 75 Ω, Optical connector x 1
Audio output (analog audio) 2.0 Vrms (1 kHz, 0 dB), 600 Ω,
RCA jack (L, R) x 1 / SCART x 2
Accessories
RF cable (1), Remote control (1), Batteries (1)
32
Resetting the unit
If you observe any of the following symptoms.
The unit is plugged in, but the power will not turn on or off.
The front panel display is not working.
The unit is not operating normally.
You can reset the unit as follows.
Press and hold the POWER button for at least five seconds. This will
force the unit to power off then turn the unit back on.
Unplug the power cord, wait at least five seconds, and then plug it in again.
To Previous Page
Loading...
Need help?
Video and Audio Formats
