Lippert Components LCI User Manual

Rev: 10.20.20 Page 10 CCD-0001526
Jack Retract Procedures
1. Energize the system by pushing ON/OFF (Fig 11A) button on touchpad. The ON/OFF light (Fig. 11E)
will be lit.
2. Push the RETRACT ALL JACKS (Fig.11D) button. All the jacks will start to retract and return to the full
retract position. When jacks return to full retract position the JACKS DOWN (Fig.11G) light will go out.
NOTE: If you wish to stop the jacks from retracting, turn the system off and back on again by pushing the
ON/OFF button twice. You can then re-level the coach by following steps 1-6 again.
3. When the JACKS DOWN (Fig.11G) light goes out, push the ON/OFF (Fig 11A) button on the touchpad
to de-energize the system. After a brief visual inspection around the coach to verify the jacks are fully
retracted, you may proceed to travel.
NOTE: When in the MANUAL mode, if the RETRACT button is pushed the jacks will only retract as long as
the RETRACT button is depressed. In AUTOMATIC mode, the RETRACT button need only be pressed
once and released for the jacks to fully retract.
Fig. 11
A
B
C
E
F
Lifting all wheels o the ground may result in serious personal injury or death.
G
D

Lippert Components LCI Specifications

General

Brand	Lippert Components
Model	LCI
Category	Jacks
Language	English