14
Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the ANT socket on the back of your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
2. Plug the TV into a mains socket and switch on at the
mains.
3. In standby mode, press the
button on the remote
control to turn the TV on. The red LED indicator will
flash for a few seconds then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV
from the mains power. To completely disconnect the mains power, please remove the mains plug from the mains
socket.
Viewing TV Through an Aerial
The first time you turn the TV on, it will go straight into the First Time Installation
menu. Most of the settings are pre-set so you can just press OK. Please ensure the
aerial is plugged in.
4. Press the
buttons to highlight your LANGUAGE then press OK.
SCART
SPDIF
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
SCART
SPDIF
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
RF coaxial cable
(not included)
5. Press the buttons to highlight your COUNTRY then press OK.
6. Select Home Mode by pressing the OK button.
Logik 24' HD Ready LED TV with DVD Player L24HEDW19(B) Manual.indd 14 24/09/2019 14:51
To Next Page
Loading...
Need help?
General
