21
5. Turn it clockwise and screw the filter back in place.
Preventing a Frozen Water Supply Hose
If your washing machine is delivered in freezing weather conditions, leave it
at room temperature for 24 hours after you’ve set it up before using it. This
ensures there’s no ice blocking the water supply hose. If your water supply
hose freezes, add 2 or 3 litres of warm water to the drum. Then run a “Spin”
only programme.
Cleaning the Filter Net of the Water Supply Hose
1. Turn the water supply off at the tap.
2. Close the washing machine door and select “Drain” programme and press the Start/Pause button.
3. When finished, turn the power off. Loosen the water supply hose and remove it from the washing
machine.
4. Use a small brush, e.g. a toothbrush to clean the filter of the water supply hose.
5. Re-connect the water supply hose to the washing machine and turn the tap back on, checking for
leaks.
Before cleaning the drain filter, switch off and unplug the washing machine.
1. Use a coin to open the Service Flap.
Cleaning the Drain Filter
about
50°C
Be careful not to burn yourself while handling your clothes or touching the inside of the drum
after a high temperature wash.
2. Carefully loosen the drain filter. Water may drain out - this is normal.
3. Turn it anticlockwise, unscrew the filter and remove it.
4. Remove any lint and debris before carefully replacing the filter.
Wash
Delay Extra rinse Dry Start/Pause
Speed
Temp
Quickwash
Wash
Rinse
Spin
ONOFF
Dry
Iron
Air wash
Wool
Synthetics
Cotton&Linen
Prewash
Rinse Spin Dry
Time
Service Flap
Turn
L612S_WD12_IB_120627_RC_Pauline.indd 21 28/06/2012 10:00 AM
To Next Page
Loading...
Need help?
General
