24
Troubleshooting problems with your Harmony 650
In this section, you’ll find some commonly reported issues and the suggested solutions.
These solutions may help you fix problems you’re experiencing. If you still cannot fix the problem,
refer to Getting help with your Harmony 650.
The TV doesn’t turn on when starting an Activity, but using the Help button
on the remote fixes the issue.
Try increasing the • Inter-Device Delay for your television. Sometimes commands are
sent too close together for different devices and need to be spaced out more.
The TV doesn’t go to the right input when starting Activities.
Using the Harmony Remote Software, check your Activity to ensure the Activity •
is set up to use the correct input your TV needs to be set on to get a picture.
Next, check that the inputs are in the correct order for the Harmony 650 to know
how to cycle through each input. If you’re still experiencing trouble, try raising the
Inter-Device and Input Delays for your TV.
When pressing buttons in an Activity, the remote sends the command twice.
Try lowering the repeats for the device that is receiving the command. You can do •
this by using the troubleshoot option in the Harmony Remote Software.
When you try to add a new TV to your account, you get a message informing
you that you haven’t entered the correct model number.
The model number for most devices can be found on the front of the device. •
If it isn’t there, it can be found on a label on the back or bottom of the device.
The model number shouldn’t be confused with the serial number or the
model number of the device’s remote control, as many different devices by
a manufacturer can share the same remote.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
