54
DATE
22.12.2003
COMPILER TECO/ATI
REG. CODE
1-5302-467
MODEL N°
50707
DATE OF ISSUE
06-95
REVISION 05
ENDORSED
107
106
105
X
Injection pump components and disassembly
1 Delivery union
2 Filler
3 Spring
4 Gasket
5 Valve
6 Gasket
7 Spring retainer
8 Spring
9 Spring plate
10 Rack
11 Plunger
12 Pin
A = Fuel outlet union
B = Fuel intake union
C = Fastening
D = Barrel
E = RH helix
Demount in compliance with the numeric order.
Plate 9 is held firm by pins 12. Lever up by inserting a tool between
the plate and the body of the pump.
The volume shifted by delivery valve 5 is 15
mm
3
in the pump of 15
LD 315-350 and 25 mm³ in the pump of 15 LD 225 is 21 mm
3
in the
pump of 15 LD 400/440
Injection pump, body, plunger and delivery valve
Components: Dimensions mm:
1 Delivery valve A = 5.50 (nominal diam.) 225-315-350
2 Barrel A = 7,00 (nominal diam.) 400-440
3 Plunger A = 6,00 (nominal diam.) 315-350 EPA
4
Right helix B = 2.00 / 2.03
5 Delay notch C = 1.50 /1.53
6 Pump body
7 Collar
Note: The injection pump installed in engines for small vehicles,
soundproof generating sets, EPA and 15 LD 400-440
engines, are characterised by the inclusion of a collar 1
which contributes to noise-reduction.
Injection pump refitting
The plunger is fitted with helix E facing towards the outlet union A; if
it is mistakenly fitted with the helix facing the intake coupling B the
injection pump no longer operates (there is no danger of engine
runaway); complete refitting following fig. 107.
FUEL SYSTEM
To Next Page
Loading...
Need help?
General
