GB Operating manual – multifunction measuring meter XA1000 / XP200 / XP400 • 08_2015 36
Use the SmartGraph3 PC software to carry out a
detailed analysis and visualisation of your measured
results. Only by employing this PC software can all
options of the multifunction measuring meter for
visualization and functioning be utilized (e.g. data
export into an Excel/PDF file or data output in form of
a printout).
You can open a basic display of your measured values
at any time in the device (see chapter "Description of
screen elements").
Installation conditions
Ensure that the following minimum requirements for
installing the SmartGraph3 PC software are fulfilled:
• Supported operating systems
(32 or 64 bit version):
–Windows Vista
–Windows 7
–Windows 8
– Windows 10
• Software requirements:
– Microsoft .NET Framework (is automatically
installed during the software installation, where
applicable)
• Hardware requirements:
– Processor speed: 1.6 GHz, minimum
– USB connection
– 2 GB RAM, minimum
– 1 GB hard disk space, minimum
Installing the PC software
1. Download the current PC software from the
Internet. To do so, visit the website
www.smartgraph3.de/download.
2. Double-click the downloaded file.
3. Follow the instructions of the installation wizard.
Starting the PC software
1. Start the SmartGraph3 software.
2. Switch on the multifunction measuring meter (see
chapter "Switching on") if necessary.
3. Connect the multifunction measuring meter to
your PC via the USB connection cable provided in
the scope of delivery. After a few seconds (up to
one minute) the multifunction measuring meter is
automatically detected and added to the device
list in the SmartGraph3 software.
Information about using the PC software is provided in
the online help.
PC software
To Next Page
Loading...
Need help?
General
