2000-T-INS-LAB-RevC14 10
CONNECTING THE TENS DEVICE
Insert battery
TurnthedevicetotheOFFpositionbeforeinsertingorremovingthebattery.
When inserting the battery, ensure the battery polarity (+ and –) markings
match the markings on the device.
Prepare the Skin
Prepare the skin as previously described and according to the instructions
provided with your electrodes. Before attaching the electrodes, identify the area
thatyourphysician/clinicianhasrecommendedforelectrodeplacement.
1. Connect the lead wires to the electrodes: connect the lead wires to the
electrodes before applying the electrodes to the skin.
WARNING: Ensure both Intensity Control Knobs for Channel 1 and 2
are turned to the OFF Position (counterclockwise) before applying the
electrodes.
2. Place electrodes on the skin: place the electrodes on the skin as
recommendedbyyourphysician/clinician.
3. Insert lead wire connector into the device: plug end of lead wire into the
channel output port (jack) to be used; push the plug in as far as it will go.
4. Select treatment settings: ensure your unit is still set to the proper
settingsrecommendedbyyourphysician/clinician.
5. Adjusting Channel Intensity Control: locate the Intensity Control Knob
(Channel 1 or 2) at the top of the unit. Slowly turn the Intensity Control
Knob clockwise until the stimulation is at the level recommended by your
physician/clinician(if youdon’tfeelanything,turntheKnobOFFthen
ONagainandcarefullyturntheControlKnobuntilyoufeelatingling
or slight twitch under or around the electrodes). The indicator light will
illuminate when unit is in operation. Always start with the lowest setting
and increase the intensity slowly.
If the stimulation levels are uncomfortable or become uncomfortable, reduce
the stimulation intensity to a comfortable level; or cease stimulation and
contact your physician.
To Next Page
Loading...
General