12
Jets and Air Control
Jets
All spa jets are individually engineered to provide
a unique hydro-massage. Depending on the model,
your spa will have a combination of the following jets:
Cyclone Therapeutic (XL Cyclone, LS Cyclone,
& Cyclone):
Positioned to focus on large muscle groups, these
jets deliver a concentrated, high volume stream of
water for a deep massage. Each jet is fully
adjustable, allowing users to set the water flow to
the most comfortable setting. The nozzle can be
rotated to target sore muscle areas.
Cyclone Turbo Swirl Jets (XL Cyclone, LS
Cyclone, & Cyclone):
Positioned to focus on muscle tension zones, these
jets deliver a spinning V-shaped water stream for a
gentle, pulsating massage. Each jet is fully
adjustable, allowing users to set the water flow to
the most comfortable setting.
Whirlpool:
Positioned to create overall water circulation, this
mult-purpose, high volume jet provides whirlpool
action throughout the entire spa.
Euro Jets:
Positioned in the footwell or shoulder areas of the
spa, these jets deliver a penetrating massage to
dissolve tension in the lower legs. This jet is the
entry point for ozone produced during the
automatic filtration cycles, and, as such, is not
adjustable.
Note:
Ozone production is suspended when other
functions are activated on the control panel by the spa
user.
All full sized jets are adjustable from a fully open to
closed position. It is very important that you
NEVER
SHUT ALL FULL SIZED JETS OFF AT ONE
TIME!
Cleaning or Replacing Jets
Hard water can cause calcium/mineral buildup that can
restrict or bind the jets. A jet consists of a face plate
and a nozzle. Rotate these parts weekly and
remove/clean monthly to ensure free movement.
Note:
It is not necessary to drain the spa to clean or
remove the jets.
Rotating the jet face plate and nozzle
· Rotate the jet face left and right
(open and closed).
· Return the face plate to the full open position.
· Turn the jets on to high speed.
· Twist the nozzle left and right.
· Rotate the nozzle in the socket.
Note:
If the jet insert disengages from the spa
housing, see steps to reinstall below.
Cleaning the jets
To
remove
the jet insert, use the palm of your
hand to exert pressure on the face of the jet. Turn
counterclockwise until the jet “clicks”. Gently pull the
jet assembly from the housing.
To
clean
the jet insert and housing, use a
pressurized hose and spray the inside of the jet. Soak
the jet in a diluted spa cleaning solution, rinse. Wipe
the inside of the housing to remove any debris.
To
reinstall
the jet, line up the tab on the
backside of the barrel with the groove in the body. Use
the palm of your hand to gently tab the jet until it
snaps into position.
Air Controls
The intensity of the jet action can be
controlled by altering the amount of air injected with
water through the jets. Your spa has five air controls
located on the lip of the spa. Each control activates air
to specific jets in the spa allowing you to create
various combinations and levels of jet action to suit
individual preferences.
Turn the control counter-clockwise to turn the
air off and clockwise to turn air on.
Note: Air controls should be closed during heating
cycles for maximum energy efficiency.
To Next Page
Loading...
Need help?
General
