17
Temperature Controls
The maximum set temperature of the spa is
104°F (40°C) and the minimum set temperature is
80°F (27°C). The display will show the current water
temperature or, if the pump has not been running, two
dashes. If the two dashes are displayed, you must first
start the pump by pressing the “Jets 1” pad. Wait until
the water temperature is displayed (approximately 2
minutes).
The set temperature of your spa may easily be
increased or decreased at any time using the “Temp”
pad. Look at the LED display. Either the actual
temperature or 2 dashes will be displayed. Press the
“Temp” pad; the set temperature will be displayed in
the LCD window. The next touch of the “Temp” pad
will change the set temperature either up or down 1°F.
If you want to increase the temperature and the display
indicates the temperature was increased by 1°F,
continue to press the “Temp” pad until the desired set
temperature is reached.
If you want to decrease the set temperature
and the display indicates the temperature was
increased by 1°F, STOP. Wait a few seconds until the
actual temperature is displayed, then press the “Temp”
pad again. Press it again and the set temperature will
decrease by 1°F. Continue pressing the “Temp” pad
until the desired set temperature is reached.
If the spa is set in STANDARD mode or in a
filtration cycle, increasing the set temperature may
result in activating the heater. Likewise, decreasing
the set temperature may result in turning the heater off.
When the heater is operating, the LED heat indicator
will be lit.
Note: Spas that are wired 120V/20A will not heat
when the pump is on in high speed.
Note: Spas that are wired for 240V/30A will not
heat when Pump #1 is on in high speed, or
when Pump #2 is operating.
JETS
Touch the “Jets 1” pad to activate the
operation of Pump 1. The sequence of the jet action
is:
1 touch = Low Speed
2 touches = High Speed
3 touches = Off
Touch the “Jets 2” pad to activate the
operation of Pump 2. The sequence of the jet action
is:
1 touch = High Speed
2 touches = Off
The low speed operation of Pump 1 is timed to
automatically turn off after four hours of operation.
The high speed operations of Pump 1 and Pump 2 are
timed to automatically turn off after 15 minutes of
operation.
Note: Pump 1 will automatically operate in low
speed whenever the spa is in a filtration cycle or when
it calls for heat. When this automatic activation
occurs, the low speed operation of Pump 1 can not be
turned off; however, all other control functions can be
activated.
Light
Touch the “Light” pad to turn the internal spa
light on or off. The light will automatically turn off
after 1 hour of operation.
Operating Modes
Your spa comes with three primary operating
modes.
Standard Mode maintains the water at the
desired set temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least 2 minutes. The
LCD window will momentarily display “St” when this
mode is selected.
Economy Mode heats the water to the desired
set temperature ONLY during filter cycles. The LCD
window will display “Ec” when this mode is selected
and the temperature is not current. The LCD window
will alternate between “Ec” and the temperature when
the temperature is current.
Sleep Mode heats the spa to within 20°F
(11°C) of the set temperature only during filter cycles.
The LCD window will display “Sl” when this mode is
selected and the temperature is not current. The LCD
window will alternate between “Sl” and the
temperature when the temperature is current.
To Next Page
Loading...
Need help?
General
