30
Starting the Sequencer
To energize the sequencing system, press the
JETS3
button on the ELX10 control panel. Once
energized, the sequencer will open all 4 solenoid
valves and water will flow through all open jets. Two
dashed lines will be displayed in the LCD window.
Push the ON/OFF button one time and the
LCD display will now show “On”. This indicates that
the system has been activated, but no changes will
occur until a sequencing program has been selected.
Sequencing Programs
To start the sequencing program, push the
PROGRAM
button one time. The LCD will
momentarily display “P2”, and then alternate between
“P2” and “S1”. The system is now running program 2
and sequencing speed 1.
To change programs, push the
PROGRAM
button
to step through the programs. The LCD will
momentarily display the selected program (P3, P4, P5,
etc.), and then alternately display the selected program
with the sequencing speed.
Refer to the chart below to see the order in
which the valves will open and close for each
program.
To Next Page
Loading...
Need help?
General
