19
460 Series Control System
If your Topside Control looks like this, your spa
has the following features:
• Internal Lights
• Air Massage (AeroMaax)
• 2 Pumps
EL478 Topside Control
If your Topside Control looks like this, your spa
has the following features:
• Internal Lights
• 2 Pumps
EL477 Topside Control
Powerworks™ 460 Series Control
System
The Powerworks™ 460 Series Control System offers
you the ultimate in spa control. The backlit, Liquid
Crystal Display (LCD) displays current water
temperature, set point water temperature, time, and
operating mode settings. Each feature of the system is
actuated through a control panel touch pad. Touch the
appropriate pad to activate the desired function.
At start up, when power is supplied to the spa, the
controls will operate properly and safely under the
factory settings. The spa will be in Standard Mode,
have a temperature setting of 100°F, and a filtration
cycle duration of 2 hours. To fully utilize the unique
capabilities of the control system, it is important to
know how to set the temperature, operate the pumps,
operate the light, adjust the mode setting, and change
the filtration cycles.
Note: In event of a power outage or failure, the 460
Series Control System should retain all settings, except
time of day. If settings are lost, re-program per the
instructions in this manual and contact your dealer.
User’s Pads
User’s Pads are the buttons located on the topside
control panel and are used to program various spa
functions (i.e., turn on spa light, set temperature, etc.).
The following table defines the pads:
To Next Page
Loading...
Need help?
General
