Mahindra 10 Series User Manual

DRIVING THE TRACTOR
STARTING THE ENGINE
Before starting the engine carry out the pre-operational checks as set out on page 23.
(1)
Sit on the driver seat
(1)
Sit
on
the
driver
seat
(2) Apply the footbrake.
(3) Put the hydraulic lever in the down position.
(4) Push down the clutch to activate the safety-starting switch.
(5) Put the main gear lever in neutral.
(6) Insert the ignition key and turn it on.
(7) Ensure that the warning lights are working.
(8) Operators need to turn key to the “ON” position.
The glow circuit automatically activates.
O t d t it f l li ht t t ff
Never turn the key to the start position while the engine is running as this can
cause serious damage to the starter and engine flywheel.
Only engage the starter for a period of not more than 10 seconds.
O
pera
t
ors nee
d
t
o wa
it
f
or g
l
ow
li
g
ht
t
o
t
urn o
ff
.
As the lamp goes off turn the key to the start position to start the engine.
(9) Ensure that all the warning lights are off with the engine running.
If Engine does not start, rest the starter for about 20 seconds and try again for a
maximum of 10 seconds.If the engine does not start after repeated attempts,
refer to the fault tracing guide.
Especially in cold weather, always allow the tractor to idle for a while to warm
up & build up sufficient oil pressure to ensure normal operating temperature for
Itt
Important
STOPPING THE ENGINE
-After light work let the engine idle for a while and turn the key off.
longer engine life.
I
mpor
t
an
t
52
After long or heavy work allow the engine to idle for 5- 10 minutes and turn the
key off.
Important

Mahindra 10 Series Specifications

General

Brand	Mahindra
Model	10 Series
Category	Tractor
Language	English