CHECKING THE WIRING HARNESS AND FUSES
Loose wires make inferior connections and damaged wires can cause short circuits, fires burnt wiring
or reduce efficiency of components.
Replace or repair any faulty wiring or insulation.
If a fuse burns out again after it has been replaced, do not replace it with wire or a high capacity fuse. ,
Incorrect wiring or fuses can cause fires to both the tractor and surrounding area,
so get the dealer to check it annually.
Likewise, fuel pipes and wiring age with use.
Find the cause and rectify it or get an auto electrician to do so.
Where insulation is chafed or peeled off, recover the area with a good quality insulation tape.
Where wiring comes out of it’s fitting, replace it correctly with the standard fitting.
s
your
ea
er to c
ec
t at
east once every
years an
rep
ace as requ
re
.
► REPLACING FUSES
The circuit has 8 blade type fuses in its wiring circuit
(See diagram on page 104, 105 and 107).
When a fuse has blown, replace it with one of the same value.
Using a large capacity fuse or wire, burns out the wiring system.
Use fuse tongs to replace fuses .
► MAIN FUSES
The wiring harness is equipped with 3 main fuses who’s
function is to preserve the wiring.
However, when a main fuse blows the entire circuit is dead.
Always check the reason & rectify before replacing the
Always check the reason for a blown fuse otherwise the new fuse is also likely to
blow.
NEVER EVER USE WIRE in place of correct grade fuse.
fuse of the same value.
To indicate that the fuse is blown, it will be discolored.
Important
SERVICE PRIOR TO DAILY AND SHORT TERM STORAGE
79
.
Wash the tractor and keep it clean.
Fill the tank to avoid condensation and rust.
Lower any attached implement to the ground before parking the tractor.
For long-term storage consult your dealer.
To Next Page
Loading...
Need help?
General