© Copyright Mahindra and Mahindra Ltd. 052016
11-9
11.6.1 How to Calculate Fuel Efficiency (Mileage)
1. Ensure recommended tire pressure is maintained
2. Refuel your vehicle till the fuel gun at the fuel station is auto-
cut-off
3. Reset trip meter to zero
4. Drive at a moderate speed for a minimum distance of 150
km
5. Refuel at the same fuel station till the auto-cut-off mode
6. Assuming ‘a’ liters of fuel was filled and ‘b’ was the trip
meter reading. Fuel Efficiency = b/a kmpl
7. We recommend that point no.2 and point no.5 should be
done in cold conditions (In mornings)
11.7 Ignition Switch (if equipped)
An illuminator ring is provided on the face of the ignition switch to
help in locating the ignition switch at night. The ring will illuminate
the moment the driver door is opened and will remain glowing till
the driver door is closed.
The different positions of the ignition switch are;
LOCK - This is the ignition and steering lock position. The vehicle
circuits and engine is completely switched OFF. The steering wheel
is also locked and the key can be removed from the ignition only in
this position.
ACC - The steering is unlocked and can be rotated. In this position all
electrical circuits are enabled. Use this mode when you want to
listen to music, etc., with the engine temporarily switched OFF.
ON - All electrical circuits are enabled. Some of the warning or
information lamps illuminate in this position. While some of the
lamps will go out after a few seconds, some will continue to remain
ON till the engine is started. When the vehicle is being driven,
ignition switch remains in the ON position.
Do not leave the ignition in ON when the engine is OFF. This
could lead to battery drain and ignition switch damage.
START - This position is to start the engine by cranking the starter
motor. This is a momentary position. When the key is turned to
start position, the starter cranks the engine. Once the engine is
STARTING AND DRIVING THE VEHICLE
To Next Page
Need help?
General
