© Copyright Mahindra and Mahindra Ltd. 052016
14-23
14.14 Bulb Replacement
14.14.1 Head Lamp Bulb Replacement
The head lamp bulb can be replaced without removing the head
lamp assembly from the vehicle. The head lamp assembly has
been removed here for illustration purpose only.
To replace the head lamp bulb;
• Ensure ignition is switched OFF
• Remove rear dust cover from the head lamp
• Remove the bulb assembly with connector from the head lamp
by unlocking the wire clamp
• Detach the bulb assembly from the wiring connector near to the
head lamp
• Insert the connector into the new bulb (of the same wattage),
and follow the reverse procedure to assemble the bulb assembly
in the headlight assembly
• Clamp the bulb assembly by wire clamp properly
Do not touch the new bulb with your fingers. Oil contamination
will severely shorten bulb life. If the bulb comes in contact with
any oily surface, clean the bulb with rubbing alcohol.
To avoid burning yourself, do not replace the light bulbs when
they are hot. Halogen bulbs have pressurized gas inside and
are to be handled with special care. Mishandling it may cause
the bulb to burst or shatter. Hold the bulb with its metal/plastic
holder/base and do not touch the glass part with bare hands.
Using bulbs with units of higher output capacity/wattage is
illegal and may damage your vehicle’s electrical system.
Replacement bulbs must meet the specification of originally
fitted bulbs.
MAINTENANCE
To Next Page
Loading...
Need help?
General
