5 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: DFT060T DFT120T
Fastening torque Hard joint 2 - 6 N•m 4 - 12 N•m
Soft joint 2 - 6 N•m 4 - 12 N•m
No load speed (RPM) 50 - 1,000 min
-1
50 - 700 min
-1
Operating temperature range 0 °C - 40 °C
Dimensions (L x W x H) with BL1815N battery 206 mm x 75 mm x 247 mm
with BL1860B battery 206 mm x 75 mm x 263 mm
Rated voltage D.C. 18 V
Net weight 1.4 - 1.8 kg
Applicable USB cable 661432-2
without notice.
-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
• Fastening torque and no load speed (RPM) can be controlled with application software designed for this tool.
Applicable battery cartridge and charger
Battery cartridge BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH / DC18WC
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Model DFT060T
Sound pressure level (L
pA
) : 70 dB(A) or less
Uncertainty (K) : 3 dB (A)
Model DFT120T
Sound pressure level (L
pA
) : 70 dB(A) or less
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING: Wear ear protection.
WARNING: The noise emission during actual
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING: Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-2:
Model DFT060T
Work mode: screwdriving without impact
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
Model DFT120T
Work mode: screwdriving without impact
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
To Next Page
Loading...
Need help?
General
