11 ENGLISH
TOOL SETTINGS
CAUTION: Make sure to adjust tool settings
according to your applications and preferences
before use.
CAUTION: Perform trial fastening, using a
torque checker etc., if necessary, so as to verify if
the updated settings are successfully applied.
NOTICE: Install the application software
designed for this tool in your computer before
time. For detailed information, refer to the installa-
tion manual supplied with the application software
designed for this tool.
A series of operation settings, including fastening
torque and no-load speed, can be adjusted via software
screen. Archiving and sharing tool preferences through
the software can enhance work performance.
Connecting with computer
NOTICE: Use the Makita genuine USB cable to
connect the tool with your computer.
1. Plug the USB cable into the USB port on your
computer.
2. Slide the USB cover open on top of the housing,
and then plug the other end of the USB cable into the
USB port on the tool.
Fig.8: 1. USB cover 2. USB cable 3. USB port
NOTE: The LED indicator on top of the rear display
-
ognizes the tool plugged into the USB port. Launch
the application software on your computer, and the
-
cation between the devices has been successfully
established.
NOTE: While connected to your computer, the LED
switch operation is available.
NOTE: Slide the USB cover close on top of the hous-
ing each time after disconnecting the USB cable from
the USB port on the tool.
To Next Page
Loading...
Need help?
General
