9 ENGLISH
LED indicator / Beeper
The LED indicators and beeper become activated when the tool works in the following operating conditions and
notify you of the tool status and performance currently delivered on the control panel.
Fig.7: 1. LED indicator A (in green, red, blue and yellow colors) 2. LED indicator B (in blue color) (* Not serve as
indicator for this model) 3. Error code 4. Status symbol
Error code
and status
symbol on
screen
Tool performance
and function
Tool status LED indicators/beeper status Action to be taken
LED indicators Beeper
- Operation check for
indicators and beeper
The tool starts to verify indica-
tors and beeper operation soon
after the battery cartridge is
installed.
The LED indicator
in green, red and
blue in order, and
then the front
lamp lights up.
A series of
very short
beeps
-
E00 Accidental start
prevention
The tool automatically stops
to avoid unintentional start-up
when the battery cartridge is
installed with the switch trigger
pulled.
The LED indicator
green alternately.
A series
of short
beeps
Release the switch
trigger.
E01 Auto-stop The battery power becomes
low and it is time to replace the
battery cartridge.
The LED indicator
green alternately.
A series
of short
beeps
Replace the battery
with fully charged
one.
E02 Anti-reset of controller The battery voltage drops
abnormally for some reason,
and the tool automatically stops
operation.
The LED indicator
green alternately.
A series
of short
beeps
Replace the battery
with fully charged
one.
E03 Auto-stop for low
remaining battery
power
The battery power is almost
used up, and the tool automati-
cally stops operation.
The LED indicator
lights up in red.
A long
beep
Replace the battery
with fully charged
one.
E04 Overload protection The tool automatically stops to
protect against a continuous
overcurrent.
The LED indicator
green alternately.
A series
of short
beeps
Remove the cause
of overload and
restart the tool. If
no improvement
is found, ask your
local Makita Service
Center for repair.
E05 Overheat protection The motor or controller gen-
erates excessive heat, and
the tool stops automatically to
protect the tool from damage.
The LED indicator
in red.
A series
of short
beeps
Remove the battery
cartridge immedi-
ately and cool the
tool down.
E06 Motor lock Motor lock has occurred, and
the tool automatically stops the
motor operation.
The LED indicator
green alternately.
A series
of short
beeps
Release the switch
trigger and pull it
again.
E07 Motor or controller
failure detection
Motor or controller failure has
been detected, and the tool
automatically stops the motor
operation.
The LED indicator
green alternately.
A series
of short
beeps
Ask your local
Makita Service
Center for repair.
E09 Torque sensor failure
detection
The torque sensor cannot
be monitored properly for a
number of technical reasons
including line breaks.
The LED indicator
green alternately.
A series
of short
beeps
Remove the battery
cartridge and cool
the tool down. If the
indicator remains lit,
ask your local Makita
Service Center for
repair.
- Auto-stop with fasten-
ing completion
The tool automatically stops the
motor operation after the pre-
set fastening steps have been
completed.
The LED indicator
lights up in green
for approximately
one second.
- -
To Next Page
Loading...
Need help?
General
