Securing workpiece
By
turning the knob on the
vise
counterclockwise, the screw
is
released and the
vise
shaft
can be moved rapidly in and out.
By
turning the knob clockwise, the screw remains
secured.
To
grip workpieces, turn the knob gently clockwise, until the projection reaches
its
topmost position, then fasten securely.
If
the knob
is
forced in or pulled out while
being turned clockwise, the projection may stop
at
an angle. In this case, turn the knob
back counterclockwise until the screw
is
released, before turning again gently clockwise.
I
Clockwise
I
CAUTION
:
Grip workpieces only when the projection
is
at
the topmost position. Otherwise the
workpiece cannot be properly gripped and
might
pop
out or damage the blade.
(Dangerous way
to
grip workpiece)
When making miter cuts of
30
degrees or more to the side that the
vise
is
mounted, the
safety cover movement may be slightly obstructed by the vise. If this situation occurs,
re-mount the
vise
on the other side of the tool’s base.
10
To Next Page
Loading...
Need help?
General
