Operation
59
Carefully read these Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
7.3.2 Checking the coolant
WARNING
Risk of injury due to hot fluid
Coolant gets hot during operation and causes scalding if touched.
For this reason:
S Undo the cap with safety valve carefully.
S Drain the pressure.
S Open the cap carefully.
User tip
The cooling system is not included in MAN's scope of delivery.
Check the coolant level as indicated in the manufacturer's operating instructions.
7.3.3 Topping up the coolant
WARNING
Risk of damage due to excessive temperature difference
Engine damage
For this reason:
S Do not fill with cold coolant.
S Allow the engine to cool down.
User tip
The cooling system is not included in MAN's scope of delivery.
Add coolant according to the manufacturer's operating manual.
ENVIRONMENTAL NOTE
Do not let coolant drip or leak out while refilling. Do not let coolant leak out onto the ground or into bo
dies of water otherwise this will cause damage to the environment.
Fill the cooling system of the engine with a mixture of tap water and ethylene glycol antifreeze agent or an
ticorrosion agent.
To Next Page
Loading...
Need help?
General
