SAFETY INFORMATION 5540F/YB5515 OPERATOR’S MANUAL
2-24 Published 10-21-2011, Control # 055-03
OVERLOAD INSPECTION
This information supplements the Load Moment Indicator
(LMI) manual supplied with each Grove crane.
When the LMI system has acknowledged an overload on
your crane, you must carry out specified inspections on
the crane.
These inspections apply only to overloads up to 50%. For
overloads of 50% or higher, crane operation must be
stopped immediately and Crane Care must be contacted
for corrective action.
NOTE: If your crane is equipped with CraneSTAR, an
overload warning will be posted to the web site
for review by the crane owner.
Overload warnings do NOT indicate real time
events! Warnings could be sent 24 hours (or
more) after the actual event.
Boom Inspection
WARNING
Overload Hazard!
To avoid an accident caused by overload damage to
your crane:
• Perform the inspections outlined in this
publication for overloads up to 50%.
• Stop operating the crane and contact Manitowoc
Crane Care immediately for overloads of 50% and
higher.
To Next Page
Loading...
Need help?
General
