GROVE Published 10-21-2011, Control # 055-03 3-11
5540F/YB5515 OPERATOR’S MANUAL OPERATING CONTROLS AND PROCEDURES
OPERATOR’S CAB
Seat Belt
The operator’s seat is equipped with a seat belt. Use this belt
at all times when operating the machine.
Seat Adjustment
Adjust the operator’s seat correctly. Full foot pedal control
must be obtained with your back firmly against the seat back.
SEAT FORE & AFT ADJUSTMENT - To adjust the seat,
move the control lever (Figure 3-25) to the right. Move the
seat to proper position and then move the control lever back
to the left to lock the seat position.
Cab Door (Enclosed Cab)
Opening the Cab Door From Outside (Enclosed Cab)
Pull the door latch out to release the cab door latch
(Figure 3-26).
Opening the Door From Inside (Enclosed Cab)
Pull the door handle back to release the cab door latch
(Figure 3-27).
p0301
Typical Load Moment Indicator -
Wylie
FIGURE 3-24
w0003
The operator’s seat is equipped with a seat belt. Use this belt at
all times when operating the machine.
p0899
Seat Adjustment
FIGURE 3-25
p0284
Opening Door - Outside
FIGURE 3-26
To Next Page
Loading...
Need help?
General
