To Next Page

To Previous Page

Part Number: 000015431 Rev01 5/19 41

Step 1 Open the front door to access the evaporator

compartment. Ice must not be on the evaporator during

the clean/sanitize cycle. Follow one of the methods below:

• Press the power switch at the end of a harvest cycle

after ice falls from the evaporator(s).

• Press the power switch and allow the ice to melt.

• Use the touchscreen to initiate a manual harvest cycle.

Notice

Never use anything to force ice from the evaporator.

Damage may result.

Step 2 Remove all ice from the bin/dispenser.

Step 3 Press the Clean button and select “Turn off

when complete”. Water will flow through the water dump

valve and down the drain. Wait approximately 1 minute

until the water trough refills and the display indicates Add

Chemical. Add the proper amount of ice machine cleaner

to the water trough by pouring between the water curtain

and evaporator, then confirm the chemical was added.

NOTE: There is a 10 minute time limit to confirm chemical

was added.

• Confirmation is pushed within 10 minutes - The ice

machine will start a 10 minute wash cycle, followed by

6 rinse and flush cycles.

• Confirmation is not pushed within 10 minutes - The ice

machine will skip the 10 minute wash cycle and start 6

rinse and flush cycles.

Step 4

Model Amount of Cleaner

IF0600C/IBF0620C/IBF0820C

IF0900C/IBT1020C/IT1200C

5 ounces (150 ml)

IF1400C/IF1800C/IF2100C 9 ounces (265 ml)

Manitowoc IYF0900C Technician's Handbook

Other manuals for Manitowoc IYF0900C