Installation Instructions Section 2
2-6
Part Number 000001590
Step-by-Step Installation Procedure
1. Prepare the site by following the instructions under
Electrical Service and Water Supply and Drain
Requirements.
2. Remove ice machine from carton.
3. Inspect for damage.
4. Remove literature/warranty packet and drain hose
from inside the ice machine.
5. Adjust leg levelers (or install optional legs). Refer to
Leveling the Ice Machine on page 2-6 and Leg Option
on page 2-7.
6. Reverse door if desired. See Reversing Door Swing
on page 2-8.
7.
For a gravity drain, install drain hose to drain on back
of ice machine and route to open site drain. For
optional drain pump method, see Drain Pump Option
on page 2-7. Refer to Water Supply and Drain
Requirements on page 2-4.
8.
Use compression fitting to connect the Water Inlet
on back of ice machine to the prepared 1/4" ID cold
water line. Refer to Water Supply and Drain
Requirements on page 2-4.
9. Open the shut-off valve on the water line.
10. Connect electrical plug to grounded (three-prong),
polarized outlet. See Electrical Service on page 2-3.
Check all visible connections for water leakage.
The ice machine must be grounded in accordance
with national and local electrical codes. Do not use
an extension cord or adapter.
Improper water supply and drain connections can
result in personal injury and substantial property
damage. These connections are the responsibility
of the owner/operator.
To Next Page
Loading...
Need help?
General
